A Diglett Pen/Pencil holder for your desk.
--Print Profile AMS---The Model has 5 colors if you use the Print Profile right after the bottom part is finished there is a pause put in so that you can swap the bottom color out of the AMS with red for the nose. The pause is about an hour and ten minutes.
The Pictures show the model Scaled to 80% the holes are approx. 12.5 mm at 80% If you use the raw File and not the Print Profile you add a height range mod. for the bottom for fuzzy skin setting i used: Contour, Point dist. .3, Skin Thick .6.
The if you scale it down to 80% add a 2nd Height range mod. for the top of the model 114-120 mm to slow the top of the model way down the last few layers lay right on top of each other and at least for me i had to slow them down i used Speeds: Outer-160mm, Inner-30mm, Sparse-30mm, Internal-30mm Then just add the pause in after the bottom if you only have 1 AMS and you want to print in 5 colors. just do it at least one layer after the printer starts printing the second color.
If you keep it at 100% scale you just need to do the fuzzy skin contour for the bottom. The holes are 16mm at 100% scale
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.