Keychain Spinner
Copyright Claim
Keychain Spinner
Boost
7
10
2
GIF
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
32 min
1 plate
Boost
7
10
2
1
11
8
Released
Description
This is the second version of the Keychain Spinner. This version is a bit bigger, more durable and smaller tolerances for a smother spin. Your print may fee “sticky” straight after print, simply use and spin the inner disk and over time and it will become smoother.
Comment & Rating (2)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
Printed with PETG, and it was an easy print. Even without spinning much, it was smooth, this is probably the best key spinner that I've found so far.
The designer has replied
0
Reply
Thank you very much.
Try the V3! It's a bit bigger but feels even better in my opinion.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld