Minimalist & low profile poop chute - adapted for rear spool
Remixed by
Copyright Claim
Minimalist & low profile poop chute - adapted for rear spool
Remixed by
Boost
7
16
6
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
3.1 h
1 plate
Boost
7
16
6
0
40
34
Released
Description
Made a custom poop chute because I couldn't find one that fit my needs. It needed to :
- Be low profile & stay behind the printer
- Use a stock scraper magnet
- Be used in conjunction with a spool in the stock spool holder configuration
- Be cat “proof” → I managed to do this by using the spool as a top cover, and contouring it with the poop chute. This also prevents poop from going outside the chute.
I printed mine in Sunlu PLA Matte Black.
Enjoy!
Comment & Rating (6)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
I needed to notch out the wall a bit to prevent it from catching on a spool
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Works well. Had to trim one of the sides slightly to fit a specific spool and keep it from rubbing. Thanks!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Perfect print !
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Related Models
© 2024 MakerWorld