Denver Broncos
Copyright Claim
Denver Broncos
Boost
10
15
6
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
10 h
2 plates
Boost
10
15
6
1
33
47
Released
Description
Another lightbox I made, just wanted to share.
Comment & Rating (6)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
Other Issues:.08mm layer height is way overkill for this...I printed it at .2 and it's just as good, but it cuts about 7 hours off the print time. Also the model itself is not 100%. It's not a perfect letter D and has some weird geometry.
Worst parts about this file
1) no hole to route led power cable out of so I added a negative modifier in the slicer
2) the spot to hang it on the wall is horribly designed, with random tiny bits coming off of it
0
Reply
Boosted
My boys love this light in there room. Great design prints great.
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
This is a good design but the print profile is not great. At 10 hours this is crazy it does not need that layer height. It does print but takes forever compared to any other lightboxes.
Edit: I actually need to take off some stars here because the back plate prints with the prime tower inside of it.... Had to cut that off and the edge looks terrible.
(Edited)0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld