Bambu Lab P1P Clean Look
Copyright Claim
Bambu Lab P1P Clean Look
Boost
104
147
51
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
5.6 h
1 plate
Boost
104
147
51
12
393
425
Released
Description
This is a simple cover for the front, purely cosmetic, but makes the P1P a touch nicer 🤩
You will need the back of screws from the P1P which is labelled “For Shell”
These can be used to secure all the parts, super easy.
BOM (but not necessary)
(2x) M3 40mm
(2x) M4 Nut
It's recommended but can be skip it and just use the “connector” pieces. These will hold it in place while it's screwed to the frame with the black screws that are included.
Thank you
Comment & Rating (51)
All
Printed great!
0.2mm for all layers
5mm brim
no supports
15% infill, cubic
2 walls
208C Generic PLA
Glue on plate, 65C
Standard speed.
2
Reply
lmfao I legit have the same phone holder that matches with the rest of it too. nice!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
brilliant worked first attempt, solid profile
1
Reply
what tablet did you attach to your P1P? I would love to do the same!
0
Reply
Replying to @stevense
it's a Nvidia shield k1, the holder I used is on thingyverse
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Sieht gut aus und ist passgenau. Allerdings empfehle ich, die langen Teile stehend einzeln zu drucken. Nach 4,5 Stunden hat es mir 2 Teile umgerissen und der ganze Druck war ruiniert.
0
Reply
Super Ergebnis, ich bin begeistert. Danke für den tollen Entwurf.
Allerdings hat es mehrere Versuche gebraucht, da es mir wie @DaShark erging. Nach ca. 4,5 Stunden fielen 2 von den langen Teilen um, und der ganze Druck war nicht zu gebrauchen. Deshalb empfehle ich, die langen Teile einzeln zu drucken. Stehend mit etwas Kleber aus dem Bambu-Stift hat das gut geklappt.
0
Reply
really nice look
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I had issues with adhesion. first try with green was my fault (forgot to change plate style because I’m new to bambu). second try it knocked over 2 of them and I tried letting it finish but in the end canceled it. but in the end after separating the prints it turned out fantastic! love the sleek look
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld