I created a set of Super Mario characters in watercolor for my son's room.
One of these characters is Donkey Kong . It is created in Hueforge.
If you use more than one of my characters, use the same filament for grey, black and white so that all the pictures match each other.
See my other paintings
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 5
PLA BambuLab Matte Lemon Yellow Transmission Distance: 4
PLA BambuLab Basic Orange Transmission Distance: 10
PLA BambuLab Matte Ash Gray Transmission Distance: 1.5
PLA META Sunlu Yellow Transmission Distance: 13
PLA BambuLab Matte Ivory White Transmission Distance: 4
Swap Instructions:
Start with Charcoal
At layer #4 (0.4mm) swap to Red
At layer #5 (0.48mm) swap to Lemon Yellow
At layer #6 (0.56mm) swap to Orange
At layer #9 (0.8mm) swap to Ash Gray
At layer #11 (0.96mm) swap to Yellow
At layer #12 (1.04mm) swap to Ivory White for the rest.
The model is not as tall as your last slider. Consider checking the Full Range button or change your Depth Mode.