Bambu Lab X1C Anti-Vibration Feet Adapter with lip
Remixed by
Copyright Claim
Bambu Lab X1C Anti-Vibration Feet Adapter with lip
Remixed by
Boost
68
141
62
Print Profile(2)
0.2mm layer, 3 walls, 20% infill, Support exclusions added
Designer
2.4 h
1 plate
PETG, 0.2mm layer, 101% scale, 20% gyroid
2.7 h
1 plate
Boost
68
141
62
1
372
256
Released
Description
Adapters to help Bambu Lab's anti-vibration feet stay more stable. A redraw of Lukas' adaptation of the original found at https://www.thingiverse.com/thing:6107428 by Igor Kalishevsky. I like Lukas' inclusion of the bit to keep the feet from moving too much, but the feet kept falling out for me, so I added a lip to hold it in.
To get the feet in, hold it with both hands, and with two fingers, start pushing it down and under the lip, working your way around to get it all.
Warning: The anti-vibration feet are held in well and are hard to get back out if needed. I just used channel-locks to squeeze on the adapter near the top of the foot, breaking the adapter open.
Comment & Rating (62)
All
So much better, solves many problems of these feet which seem to be made for something other than feet, they are probably just random rubber spring
The designer has replied
2
Reply
Thanks for sharing!
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill, Support exclusions added
👍Adapter works (BL PLA-cf) with anti-vibration feet (TPU Eryone - Générique TPU Profile) but In my case, the feet (X/Y) scale had to be revised
The designer has replied
1
Reply
Thanks for sharing. As stated, the adapter was built for the Bambu Lab antivibration feet. Glad you could adapt the other foot model to fit.
0
Reply
Was thinking on getting one of those desktop folder holders and then I saw this model.
Took a few hours to print but came out nice.
Thanks.
The designer has replied
1
Reply
Looks great, thanks for sharing!
0
Reply
Quick print, great fit.
Thanks for the model!
(Edited)
The designer has replied
1
Reply
Thanks for sharing!
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill, Support exclusions added
worked very well on my cheap AliExpress rubber feet!
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill, Support exclusions added
Fits perfectly. Now I'll test it, but the print is fine
1
Reply
Printed perfect. THX
1
Reply
Printed perfect. THX
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill, Support exclusions added
Great!
The designer has replied
0
Reply
Looks good! Can I ask why you rated 3 stars? Did something not work as well?
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill, Support exclusions added
The designer has replied
1
Reply
They look great!
(Edited)1
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (2)
© 2024 MakerWorld