This is a set of lid spacers that lift the rear edge of the Bambu Lab P1P, P1S, and X1C top glass to allow heat to escape the printing chamber, eliminating the chance of heat creep. I originally downloaded and printed some spacers to elevate the front edge of the glass but the fan noise as too loud so I designed these rear spacers.

The spacers are tapered to match the slope of the glass to reduce stress on the lid, even with an AMS sitting directly on the glass lid. The built-in lip wraps around the top edge of the printer to make sure the spacers don't shift or fall out of place during printing.

I printed them out of PLA, 3 perimeter walls, 10% infill, no supports or brims.