PTFE cable chain clip for P1P/P1S and X1C
Copyright Claim
PTFE cable chain clip for P1P/P1S and X1C
Boost
531
1112
460
Print Profile(4)
0.2mm layer, 3 walls, 15% infill
Designer
18 min
1 plate
0.2mm layer, 6 walls, 15% infill
Designer
16 min
1 plate
PETG - 0.2mm layer, 3 walls, 15% infill
18 min
1 plate
0.12mm layer, 3 walls, 15% infill
22 min
1 plate
Boost
531
1112
460
4
3.3 k
2.2 k
Released
Description
Clips onto the Cable chain very securely and rigidly. Then snap in the bowden tube.
Use pliers to remove the clips by slowly lifting one end from the cable chain.
The clips are very sturdy and dont move much.
Comment & Rating (460)
All
printed out great.
1
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
Very good
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
prints well, snug fit. so far it looks to keep my ptfe tube from rubbing the upper glass.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Cool!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Nice fit
0
Reply
Print Profile
PETG - 0.2mm layer, 3 walls, 15% infill
Looks great
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
super
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
tight fit, working great! printed in ABS
0
Reply
Print Profile
PETG - 0.2mm layer, 3 walls, 15% infill
top 👍🏼
0
Reply
Print Profile
PETG - 0.2mm layer, 3 walls, 15% infill
Quick and easy solution. Thanks!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld