A1/ A1 Mini Goofy Guy Front Cover And Extruder Wheel
Copyright Claim
A1/ A1 Mini Goofy Guy Front Cover And Extruder Wheel
Boost
42
72
55
GIF
Print Profile(1)
0.12mm layer, 3 walls, 15% infill
Designer
1 h
1 plate
Boost
42
72
55
3
168
152
Released
Description
Cover has been made from scratch, which means it would fit your A1 or A1 mini very well,
just pop out the extruder wheel once its printed, and put the parts on the frontend of the extruder.
i suggest you raise the infill % since the small tabs can fall off, i never has such issue with this cover, but i can see a few other have.
all colors are changeable
Stay tuned for more uploads, but meanwhile you can check my other modifications for the A1 and A1 mini :)
Comment & Rating (55)
All
Print Profile
0.12mm layer, 3 walls, 15% infill
Top tab broke off. This does not have the right dimensions. would been nice if it fit. I hooked the top first. but the bottom part that sticks out was hitting. was going to give 4 stars but I did what I’d like others to do for me. it just isn’t quite right. The tabs need to be stronger.
The designer has replied
0
Reply
Well it has been printes alot of times without problems i suggest you raise the infill percentage to keep them stronger, what material did you use?
ill look into a solution for This
0
Reply
Replying to @Kugelmann
ok ty
0
Reply
Boosted
FOR YOUR GREAT JOB
The designer has replied
0
Reply
ty :)
0
Reply
Boosted
I LOVE THIS FACE
The designer has replied
0
Reply
nice!!
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
Auch in anderen Farben super.
Passgenauigkeit perfekt
The designer has replied
0
Reply
wow! nice one :)
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
(Edited)
The designer has replied
0
Reply
nice
(Edited)1
Reply
Replying to @Kugelmann
Ja danke
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
The designer has replied
0
Reply
nice! :)
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
tabs snapped off. pla probably not the best material
The designer has replied
0
Reply
i know, thats why i suggest using a higher infill if that problem shows up, i never had such problems with PLA
0
Reply
the tabs are all walls with no room for infill. infill only gets applied to the thicker parts. we can redesign the tabs to be thicker to solve this.
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
Looks cool! but for me the turning eye always falls out because the hole is a bit to large.
The designer has replied
0
Reply
hrmmm weird her about some who had them too small, try heat it a bit with a lighter shortly and presse it a bit before you insert it
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
it printed fine but the tabs at the top break off very easily. you have to be super careful when installing the plate.
The designer has replied
0
Reply
raise the infill percentage
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
very good. printe fro the app
The designer has replied
0
Reply
Nice
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld