0.12mm layer, 4 walls, 22% infill, no supports/brim, conservative flush volumes and flush to infill
52.2 h
2 plates
Boost
37
69
4
0
80
33
Released
Description
What is Print in Place PLUS? It's adding filament change stops to insert parts.
Filament changes are set to 13.4, 29.6, 53.0, & 69.4 (for .30mm layers 69.5)
Do not change color, instead just add tires and restart with same color.
Tires will be printed into the truck permanently.
CAUTION - Be sure tires clear Pinda Sensor and Nozzle before continuing!!
it will be close but should not interfere. Follow directions step-by-step:
Step 1: Print 10 Tires. You will need these when printing the main truck.
Step 2: At each stop add 2-3 Tires. Direction doesn't matter, they are symmetrical. Make sure they sit all the way down and clear the nozzle before continuing. Gentle- Dont snap them off print bed.