Statue of Liberty Multipart print
Remixed by
Copyright Claim
Statue of Liberty Multipart print
Remixed by
Boost
43
58
10
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
8.3 h
3 plates
Boost
43
58
10
0
170
168
Released
Description
This is a multipart version can can be printed more easily but also bigger.
You print the Base, Statue, Flames and the Crown separately and glue them together afterwards. The crown can also be easily be repaired with the separate file.
Both the STL and the 3mf files are included.
I have printed with the following materials:
- Base - Marble PLA
- Statue - Silk Rainbow PLA
- Crown - Silk Rainbow PLA
- Flame - Silk Gold PLA
Printed at 0.2 layer height and 3 layers perimeter and lightning infill
Comment & Rating (10)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Awesome model!
1
Reply
Great looking print. Model is completely hollow, and parts must be glued together. Some infill and some alignment pegs would take this model to the next level.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Could’ve used more infill in the stand for a better top surface, and would be better to have the statue without a crown so that you don’t need to remove the poorly printed crown first before glueing on the good one. But overall a nice model and easy print. Thank you.
0
Reply
thanks for print, very nice
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld