Cable Organizer P1S/P1P with AMS on the top by Downhill_Solutions

Downhill_Solutions

3D Printer>3D Printer Parts

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

0.12mm layer, 3 walls, 15% infill

Designer

43 min

1 plate

4.7(79)

0.2mm layer, 3 walls, 15% infill

27 min

1 plate

4.8(12)

0.12mm layer, 2 walls, 10% infill

34 min

1 plate

4.4(9)

Boost

372

742

116

808

568

Released

Description

cable organiser for the backside of the P1S with AMS on the top.

Should fit in P1P (upgraded thith glas top shield) / X1 / X1C.

You have to change the casing screw on the left upper plate with a longer one which is include with the Bambu Lab Printer.

Maybe you need to optimise for other filaments.

The Pin is made to fit in the underside of the cable organiser to arrited in the 3mm hole in the printer casing.

New updated Version 2 available:

https://makerworld.com/de/models/68229#profileId-72221

Comment & Rating (116)

@marian.huebner

Print Profile

0.12mm layer, 3 walls, 15% infill

Funktionen vorhanden. Druck super

The designer has replied

@Downhill_Soluti

danke für dein feedback :)

@Creative_3D

Print Profile

0.2mm layer, 3 walls, 15% infill

Prints really well. Good part for keeping things neat.

@NautilosPrints

Print Profile

0.12mm layer, 3 walls, 15% infill

worked out perfectly

@dierk24

Print Profile

0.12mm layer, 3 walls, 15% infill

Super geil geworden. Damit hab ich endlich Ordnung hinter meinem AMS.

@LaughingBehr3D

Print Profile

0.12mm layer, 3 walls, 15% infill

pretty good. could use a little modularity for people with AMS risers

@Mechengg

Print Profile

0.12mm layer, 3 walls, 15% infill

The print itself is good, supports presented, easy to clean up and good function of cable management. However this doesn't work at all. It pulls the tubing too tight as it exits the AMS unit and will cause you issues with retraction. I installed it, had issues, removed it and all of my problems were gone. Good in theory, poor in execution

(Edited)

The designer has replied

@Downhill_Soluti

Hi and thank you for your feedback! I have upgraded a new and better Version 2 of the cable organizer, which remove exactly the problem you got. Please check out my new Version and test it :) have fun!

@Mechengg

Replying to @Downhill_Soluti :

Sorry this new version changes nothing in regards to how the discharge PTFE tube is held vs what the actual problem with this attachment is. you simply can't pull the tube tight into the machine so quickly, the angles become too tight. this might be OK for the electrical cord, but it causes friction and retraction issues with the PTFE tube

(Edited)

@Downhill_Soluti

Replying to @Mechengg :

I can‘t believe that. mine works fine with every filament. no problems ore any other troubles because of the organizer. even Carbon fibre filaments works perfect in every ams port. I don't think your problem caused only by the cable organizer itself. do you allredy checked your extruder and the feeder?