Bambu Lab X1C, P1S & P1P PTFE Moving Passthrough - Reduce PTFE Resistance Remixed by Bas7ard

Remixed by

Bas7ard

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 4 walls, 15% infill

Designer

26 min

1 plate

4.7(17)

Boost

126

121

Released

Description

reduce the resistance of the PTFE Tube from the tool head as it passes through the printer at the back while moving with drag chain.

Installation:

remove the rubber pass through Gasket and replace it with this. this allows the Ptfe to move left and right resulting alot lest resistance of the filament inside of it .

note the hole in the swivel piece of the design might need a light file or drill out if it prints too tight for the ptfe

Comment & Rating (19)

@user_156642827

Perfect fit, those saying it needs work it doesn't. it's meant to fit the the wall on the inside chamber not the outside look at his picture. he has the outer plate off the printer. Could use an outer plate on it, but Great print either way. Not like I'm gonna be staring at the back of the printer anyway, lmao. Great job Thanks for the share

@k.brown241

Print Profile

0.2mm layer, 4 walls, 15% infill

@VroDoPrints

Print Profile

0.2mm layer, 4 walls, 15% infill

love this a lot more over the digital where the ptfe is much more stiffer guided trough

@lainehildebrand

Print Profile

0.2mm layer, 4 walls, 15% infill

Solid print. Just didn't fit into the back of the p1p super securely.

(Edited)

@universaltechni

Print Profile

0.2mm layer, 4 walls, 15% infill

doesn’t work falls though. great concept but needs more work.

@ThisPatrik3D

Print Profile

0.2mm layer, 4 walls, 15% infill

great profile and model, thank you very much!

@cdsheets73

Print Profile

0.2mm layer, 4 walls, 15% infill

Easy print and install... looks so much better than the original piece that comes with the system!

@BJVargas

Print Profile

0.2mm layer, 4 walls, 15% infill

Works great so far better then the stock for sure

@ThaiDai

Thanks! Printing it now after having some problems with the AMS and No. 3. I hope with this one and https://makerworld.com/en/models/43132#profileId-44154 these problems will vanish.

@Szobyx

Print Profile

0.2mm layer, 4 walls, 15% infill

This remix is based on

Bambu Lab P1P PTFE passthrough

License

This work is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.