P1S P1P Blink Mini Camera Adapter Faceplate without screen mount
Remixed by
Copyright Claim
P1S P1P Blink Mini Camera Adapter Faceplate without screen mount
Remixed by
Boost
5
8
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
28 min
1 plate
Boost
5
8
6
0
19
24
Released
Description
It was requested that I upload a remix of the original that did not have the top screw mounts for the screen upgrade, so here it is :)
Remixes and suggestions always welcome and appreciated!
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
First one broke because the hole was too small.
After a modified the hole to the right size it printed perfect.
1
Reply
The ball slot is to small, was unable to mount the camera.
The designer has replied
0
Reply
Mine was pretty tight too and I really had to force it in, however, this allows it to stay in place while rotated. I had a slightly bigger design but the camera would fall down when rotated up, so I made it pretty tight. Maybe try again and hopefully it will pop into place. I'm sorry it didn't work for you, I printed with Bambu PLA on the P1S.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:not suitable for the articulated sphere of the Blink Mini, when you try to insert it the printed support breaks
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld