Summary

This is an RC Car Stand that I built to work on my Traxxas E-Revo 1/16 (it's sized so that it fits the MERV perfectly, but should be able to hold larger models as well).

Features:

Freely rotating (360 degrees)
Adjustable height (turn the M20 nut to lift / lower - independent of rotation)
Hole sets (4) for holding shocks: 10mm, 13.5mm and 15mm
Holes to hang shocks upside down for draining oil (placed above oil trays for dripping)
Multiple trays for holding parts (including one separated for front / back)
Depending on your printer and settings, prints in around 15h and uses about 140g of filament (which brings cost at about $3, so much cheaper than ordering, including AliExpress)

I used some strips of rubber I had laying around for stability, and you can use furniture feet stickers from any DYI store as well.

Print Settings

Printer Brand:

Creality

                                            Printer:                      
Ender 3 Pro

Rafts:

                                            Supports:                      
Yes

Resolution:

0.2

                                            Infill:                      
10%

Filament:

Fiberology Impact PLA

                Orange                    
                        Notes:                     I printed the top plate in PET-G and the bottom in Impact PLA, but I guess any type of PLA would work.

I'd suggest 3+ top layers for durability, but infill can be 10% (I used gyroid).

Do remember to flip the top plate and have it facing down when printing.