A pile of skulls, with some kind of slimy fluid pouring down onto them. No AMS needed, done as layer painting with Hueforge. This one is 20cm x 15.5cm and uses 8 colours.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

Filaments Used:
PLA Generic Black Transmission Distance: 0.2
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Green Transmission Distance: 2
PLA BambuLab Basic Blue Transmission Distance: 4
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA Kexcelled Lake Blue Transmission Distance: 3.6
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #10 (0.92mm) swap to Gray
At layer #13 (1.16mm) swap to Green
At layer #14 (1.24mm) swap to Blue
At layer #17 (1.48mm) swap to Red
At layer #22 (1.88mm) swap to Yellow
At layer #26 (2.2mm) swap to Light Blue
At layer #29 (2.44mm) swap to White for the rest.