Print Profile(2)
Gyro 70mm
Designer
2.9 h
1 plate
Color / Diameter: 100mm
Designer
13 h
1 plate
Boost
54
82
11
3
91
71
Released
Description
I wanted to develop a gyro that had a special design.
It should also turn extremely well and look cool.
I think I succeeded in that too.
Comment & Rating (11)
All
printed it wirt gold and copper silk pla from eryone and it turned out great!
2
Reply
Boosted
a made a 300mm one
The designer has replied
1
Reply
Cool
0
Reply
Print Profile
Gyro 70mm
Printed just fine, but the model was not as stable as one would expect, which caused it to wobble instead of spinning smoothly.
The designer has replied
1
Reply
Especially because the ones I printed rotate very well and smoothly.
0
Reply
@pipo_meier, I don’t question that it is smooth, the issue (at least with the one I printed) is that the pins aren’t spaced correctly which causes it to wobble due to imbalance. but that might also be due to some issue with my print as well.
0
Reply
Print Profile
Color / Diameter: 100mm
This is so awesome. I mess with it when I am bored
1
Reply
Print Profile
Color / Diameter: 100mm
it looks good but the tolerances are a bit tight and it seems to be the reason why some of the rings don't spin so well
0
Reply
Print Profile
Gyro 70mm
1
Reply
Print Profile
Gyro 70mm
1
Reply
Print Profile
Gyro 70mm
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld