Dune movie poster fridge magnet
Boost
18
25
10
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
2.5 h
1 plate
Boost
18
25
10
1
6
9
Released
Description
Dune movie poster fridge magnet.
Measuring 65mm wide by 95mm high by 5mm deep
4 colour AMS print, using black, brown, orange and lemon yellow.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (10)
All
Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
I'm a fan of the films, so thank you!
I printed it but I can't get the same result as yours, I don't think I have the right colors.
The designer has replied
1
Reply
Which filaments did you use?
I used sunlu black, esun brown, sunlu orange and bambu lemon yellow if that helps.
(Edited)0
Reply
Boosted
Replying to @crabstiks
I think it's the bambu lemon yellow that I'm missing, I launched another print with another color to test.
(Edited)1
Reply
Lemon yellow matte is my go to yellow colour, either bambu or sunlu... I find other yellows to be too bright
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Looks great (the picture doesn't show it well...it's really more yellow than this)
1
Reply
Boosted
I ilke it, congrat !
The designer has replied
1
Reply
Thank you!
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld