I remixed Trevstein96 which was remixed from JohnPepsis of the A1 Camera mount for WYZE V3 or ROKU SE. The model was revised to improve their designs, with the details followed in the list below:
* The Dove Tail Groove is designed to fit the bracket side LOOSELY about ~1mm of play for easy assembly and removal. Also, for user's that their printers do not have tight tolerances or proper alignment/flow rates.
* The mount is designed to lock the model tightly on the printer from left to right and downwards to flight gravity and the vibrations. If you need to remove the mount pull up on the bracket arm and slide it off. (If needed, pull up the bracket arm and from front bottom pull upwards in a swinging motion towards the front of the printer and it will allow for easy removeable in this direction as intended.)
Instructions:
-When applying the mount on to the printer remove any X Axis cable guides. Next slide the mount on flush to the A1 logo/motor while pulling up on the bracket arm into the model is pushed completely on and it will clip down on the backside.
-(if), You can reinstall your X Axis cable guides afterwards. This model allows room for many different models to fit.
I printed in PETG my preference, you can print in PLA as well.
Enjoy, leave a rating or comments if you like it or have ideas for improvements. Thanks :)