Let me tell you guys a wonderful story (and ritual) of the South American Legendary creature,

The Carbuncle.

So this little cat/fox looking thing, is said to roam the forests at night near the mines. People would come across a light in the distance signifying the presence of the carbuncle. They were said to protect a very valuable treasure (some say it was the gem located on the creatures forehead, and some say that it had other more valuable items for people who perform the ritual) Those who went too close or tried to capture the creature were often left blinded by a bright light that emanated from the creatures gem.

The ritual was extremely complicated and i do not recommend going out carbuncling.

You needed.....

Shovel
lasso or rope
a heartbroken old woman
Black cat
OK..... so you need to traverse the forest at night and when you see the light of a carbuncle, you are supposed to throw your rope or lasso at it.... Then you are to leave the rope on the ground and come back in the morning with the old woman and cat..... You would have to dig where the end of the rope landed and every few feet of digging, the old woman has to throw the cat in the hole. Somehow when you dig a few more feet the cat will be back in the old ladies arms and she will have to throw it into the hole again =/ (i'm not kidding this is really the ritual... i didn't create it, don't look at me like that) so yea you are supposed to keep digging till you find the treasure. Sometimes the treasure is sticking out of the ground a little bit and you don't have to throw the cat.... Sometimes you have to throw the cat into the hole 12 times in broad daylight with a sad old lady standing next to you....

(Omg I forgot to write…. You need to be level headed and clear minded when doing this and if you don’t throw the cat into the hole the treasure will turn to rocks and you will die 😅 sry forgot about that)

There is no moral to this story. Enjoy the Carbuncle.

(Access and commercial rights to this and all my other designs available exclusively through my patreon)

This should be a simple print, Turn up your fans and make sure your bed adhesion is on point. The regular STL is the normal size, it is pretty small but i was able to print it at 70% of that scale and i printed this design at 200% as well. The 3mf is around 180% scale. I like them with 3 walls and some gyroid infill (10%) and if you have an X1C or P1S try to print near the fan and raise up the fan speed to 100 to help any overhangs.